Identify clear alignment marks on both the encoder's shaft and the motion shaft. These marks, typically located on the end surface or body of the shaft, ensure the correct installation position of the encoder in relation to the motion shaft.
Vibration can occur when the motor of the tempering blower and the coupling of its reducer are not concentric. In this case, we should check the concentricity of the coupling, and reinstall or replace the coupling.
The heating time of the glass tempering furnace should be adjusted according to actual conditions. The size of individual glass sheets and the number of sheets placed in a single furnace cycle can significantly affect the heating duration.
When there are discrepancies in the curvature settings of the bending chillers in the glass tempering furnace, or when the glass deviates during motion, it can cause the bent tempered glass to have inaccurate curvature and its diagonal corners to not lie on the same plane.
White haze can appear in the center of tempered glass during the glass tempering process for several reasons:If the tempered glass oscillates too quickly inside the glass tempering furnace, white haze may occur……
The main operating station of the glass tempering furnace and the control boxes for the critical components are each equipped with emergency stop buttons. Should an emergency arise, the operator can instantly halt all driving operations of the glass tempering furnace by pressing these buttons.
In the field of glass tempering process, the air compressor supplying compressed air to the glass tempering furnace is very important. Not only does it provide the necessary power to various components of the glass toughening machine, but it also significantly contributes to maintaining a balance in the furnace temperature.